To Next Page

To Previous Page

NOTE. TekSecure does not erase calibration constants or instrument firmware.

TekSecure Erase Memory

Use this menu to use the TekSecure

function to erase the oscilloscope nonvolatile memory.

To open the Security menu and run TekSecure:

1. Tap Utility in the Menu bar.

2. Tap Security... .

3. Tap Run TekSecure to run the TekSecure memory erase. It will take approximately seven minutes to erase the memory.

4. To exit the dialog without running TekSecure, tap outside of the configuration menu.

NOTE. You cannot stop the TekSecure process once it is started.

NOTE. Do not power down the instrument while TekSecure is running.

NOTE. Save any important waveform, screen capture, instrument setup, report, and session files to external memory before

running TekSecure.

NOTE. TekSecure does not erase calibration constants or instrument firmware.

Security configuration menu (optional)

Use this menu to enable or disable USB ports, LAN port, Firmware updates, and securely erase the oscilloscope nonvolatile

memory (TekSecure

). Access to the functions on this menu are password protected. This menu is only shown on instruments

with optional Enhanced Security installed.

To open the Security configuration menu:

1. Tap Utility in the Menu bar

2. Tap Security.

3. Tap On or Off to enable or disable USB Ports, LAN port, or Firmware Updates functions. The default setting is On.

NOTE. Enabling/Disabling the LAN port is not available on the MSO58LP.

4. Tap Set Password to enter a password for the first time. If a password has already been set, tap Change Password to

change the password.

NOTE. The switches cannot be toggled (off or on) unless a password has been set.

■

If a switch is toggled without a password set, a message is shown to set a password.

■

If a switch is toggled with a password set, the instrument shows the Enter Password menu.

Menus and dialog boxes

MSO54, MSO56, MSO58, MSO58LP, MSO64 Help 299

Tektronix MSO58 Printable Help

Other manuals for Tektronix MSO58