Tektronix MSO58 Printable Help

Ethernet serial bus trigger settings panel
NOTE. Requires option SRENET.
Field or control Description
Source Select the Ethernet bus on which to trigger.
Trigger On Select the type of information on which to trigger.
MAC Address Destination,
Source
Sets the MAC destination and/or source address pattern on which to trigger.
Tap a Binary or Hex field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available when Trigger On = MAC Addresses.
MAC Length/Type Sets the MAC length/type pattern on which to trigger.
Tap a Binary or Hex field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available when Trigger On = MAC Length / Type.
MAC Length/Type Low, MAC
Length/Type High
Sets the boundary MAC length type conditions when testing for in-range or out of range
conditions.
Available when Trigger On = MAC Length / Type and Trigger When = Inside Range or
Outside Range.
IP Protocol Sets the IP protocol pattern on which to trigger.
Tap a Binary or Hex field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available when Trigger On = IP Header.
Source, Destination Address Sets the source and/or destination IP address pattern on which to trigger.
Tap a Hex or Decimal field and use the A and B knobs to select and change the values. Or
double-tap on the field and use the virtual keypad to enter values.
Available when Trigger On = IP Header.
Source Port, Destination
Port
Sets the source and/or destination TCP header port pattern on which to trigger.
Tap a Binary, Hex or Decimal field and use the A and B knobs to select and change the
values. Or double-tap on the field and use the virtual keypad to enter values.
Available when Trigger On = TCP Header.
Sequence Number Sets the TCP header sequence number pattern on which to trigger.
Tap a Binary, Hex or Decimal field and use the A and B knobs to select and change the
values. Or double-tap on the field and use the virtual keypad to enter values.
Available when Trigger On = TCP Header.
Menus and dialog boxes
350 MSO54, MSO56, MSO58, MSO58LP, MSO64 Help

Tektronix MSO58 Specifications

General

Brand	Tektronix
Model	MSO58
Category	Test Equipment
Language	English