2.Glossary
Stop Category 0
Robot motion is stopped by immediate removal of power to the robot. It is an uncontrolled
stop, where the robot can deviate from the programmed path as each joint brake as fast as
possible. This protective stop is used if a safety-related limit is exceeded or in case of a fault
in the safety-related parts of the control system. For more information, see ISO13850 or
IEC60204-1.
Stop Category 1
Robot motion is stopped with power available to the robot to achieve the stop and then
removal of power when the stop is achieved. It is a controlled stop, where the robot will
continue along the programmed path. Power is removed as soon as the robot stands still. For
more information, see ISO13850 or IEC60204-1.
Stop Category 2
A controlled stop with power left available to the robot. The safety-related control system
monitors that the robot stays at the stop position. For more information, see IEC60204-1.
Category 3
The term Category should not be confused with the term Stop Category. Category refers to
the type of architecture used as basis for a certain Performance Level. A significant property
of a Category 3 architecture is that a single fault cannot lead to loss of the safety function.
For more information, see ISO13849-1.
Performance Level
A Performance Level (PL) is a discrete level used to specify the ability of safety-related parts
of control systems to perform a safety functions under foreseeable conditions. PLd is the
second highest reliability classification, meaning that the safety function is extremely
reliable. For more information, see ISO13849-1.
Diagnostic coverage (DC)
is a measure of the effectiveness of the diagnostics implemented to achieve the rated
performance level. For more information, see ISO13849-1.
MTTFd
The Mean time to dangerous failure (MTTFd) is a value based on calculations and tests used
to achieve the rated performance level. For more information, see ISO13849-1.
Integrator
The integrator is the entity that designs the final robot installation. The integrator is
responsible for making the final risk assessment and must ensure that the final installation
complies with local laws and regulations.
Risk assessment
A risk assessment is the overall process of identifying all risks and reducing them to an
appropriate level. A risk assessment should be documented. Consult ISO12100 for further
information.
User Manual 235 UR10
2.Glossary
Copyright © 2009–2020 by UniversalRobotsA/S. All rights reserved.
To Next Page
Loading...
Need help?
General
