Universal Robots UR10/CB3 User Manual

1.9.7. Robot connection
The cable from the robot must be plugged into the connector at the bottom of the control box,
see illustration below. Ensure that the connector is properly locked before turning on the robot
arm. Disconnecting the robot cable may only be done when the robot power is turned off.
CAUTION
1. Do not disconnect the robot cable when the robot arm is turned on.
2. Do not extend or modify the original cable.
User Manual 47 UR10
Copyright © 2009–2020 by UniversalRobotsA/S. All rights reserved.

Universal Robots UR10/CB3 Specifications

General

Brand	Universal Robots
Model	UR10/CB3
Category	Robotics
Language	English