Uponor Smatrix Wave PLUS User Manual

8.4 Charger cable
The interface should always be charged attached to the
wall bracket, but if needed a standard mini-USB cable
can be used.
The illustration below shows where to attach the cable.
8.5 First startup guide
When starting the interface for the first time, or after
a factory reset, a startup guide is shown in the touch
screen display.
Power up the interface
The power switch is located on the lower left corner on
the back of the interface. The interface will power up
when connected to a power source.
The startup guide uses the following order:
No Description
1 Set language
2 Set regional settings
3 Set date and time
4 Set system to heating and/or cooling
5 Register the interface to a controller
All these settings are accessible in the interface menu
system.
Navigating the interface:
Icon Description
Go to home menu
Go back/cancel changes (if not saved)
Scroll up and down in lists
Scroll sideways or change sub menu (if available)
Cancel settings and return to previous menu
Move to the previous field
Decrease value
Increase value
Move to the next field
Confirm settings and return to previous menu or
continue to next step in startup guide
Settings
Appears in some menus where more specific
settings are available for a parameter
See section 14 Operate Uponor Smatrix Wave PLUS
interface for more information.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
48
UPONOR SMATRIX WAVE/WAVE PLUS · INSTALLATION AND OPERATION MANUAL

Uponor Smatrix Wave PLUS Specifications

General

Brand	Uponor
Model	Smatrix Wave PLUS
Category	Floor Heating Systems
Language	English