Initial Setup
WorkCentre 7800 Series Multifunction Printer 27
System Administrator Guide
Setting the Date and Time
Setting the Date and Time in CentreWare Internet Services
1. In CentreWare Internet Services, click Properties > General Setup.
2. Click Date and Time.
3. Under Date and Time Setup, select:
− Automatic using NTP to allow the NTP service to set the time automatically.
− Manual (NTP Disabled) to set the date and time manually.
4. If you are using an NTP server, select the address type. Options are IPv4 Address or Host Name.
Type the appropriately formatted address, alternate address, and port numbers. The default port
number is 123.
Note: Changes to these settings cause the printer to restart.
5. Select the date and time format, and type the date and time in the appropriate fields. Select the
Display 24 hour clock check box to show the time in 24 hour format.
6. Under Time Zone, select your time zone from the drop-down menu.
7. Click Apply.
Setting the Date and Time at the Control Panel
1. At the printer control panel, press the Machine Status button, then touch the Tools tab.
2. Touch Device Settings > General > Date & Time.
3. To set the time zone, touch Time Zone and touch the arrows to adjust the time zone.
4. To set the date, touch Date, select a format and set the date.
5. To set the time, touch Time and set the time. Select Display 24 hour clock to use 24 hour format.
6. Touch Save.
To Next Page
Loading...
Need help?
General
