Yealink VCM38 Administrator's Guide

| Basic Settings | 137
About this task
This feature is only applicable to MeetingEye 600/MeetingEye 400/PVT960/PVT940/VC200/VC200-E.
Procedure
1. On your web user interface, go to Setting > USB Config.
2. Configure and save the following settings:
Parameter Description Configuration Method
Auto Upload Screenshot
Enable or disable the auto-
uploading of screenshot to YMS.
• On
• Off
Default: Disabled.
Web user interface
Related tasks
Configuring Local Storage
Configuring USB Storage
Configuring the Screenshot
Configuring Video Recording
The video recording feature is enabled by default and you can configure the feature.
Before you begin
If you want to record video to USB flash drive, make sure the USB flash drive is available.
About this task
This feature is not applicable to the third generation VCS devices running in Yealink Cloud system mode.
However, you can save the recored videos to Yealink Cloud server. To record videos, go to Enterprise
Management > Collaboration Files > Recordings on Yealink Meeting Management Platform.
Procedure
1. On your web user interface, go to Setting > USB Config.
2. Configure and save the following settings:
Parameter Description Configuration Method
Recording
Enable or disable the video recording feature
on the system.
Default: On.
Web user interface

Yealink VCM38 Specifications

General

Type	Conference microphone
Noise reduction	Yes
Microphone frequency	100 - 16000 Hz
Microphone sensitivity	-45 dB
Microphone pick-up range	6 m
Number of microphone arrays	8
Maximum sound pressure level (1kHz)	100 dB
Device interface	RJ-45
Connectivity technology	Wired
Maximum operating distance	40 m
Mounting type	Ceiling
Product color	Silver
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	5 - 90 %
Number of products included	1 pc(s)
Harmonized System (HS) code	85181000
Power source	DC/PoE
Sustainability certificates	CE, Federal Communications Commission (FCC), REACH, RoHS

Weight and Dimensions

Width	127.3 mm
Height	66.3 mm