EasyManuals Logo
Home>Yealink>Conference System>VCM38

Yealink VCM38 Administrator's Guide

Yealink VCM38
281 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #169 background imageLoading...
Page #169 background image
| Configuring Video Settings | 169
2. Configure and save the following settings:
Parameter Description Configuration Method
View Switching Interval
Configure the view switching
interval.
Note: the default value is 30
seconds.
The video images will be
switched automatically every 30
seconds.
Web user interface
View Round
Configure the number of video
images to be switched at a time.
Note: the default value is 1.
Valid value: 1 - 7.
Web user interface
Full Screen Round Switches all video images
(except for the active speaker
and the content) at a time.
Web user interface
Configuring Preview Local
If there is no local screen in the current layout (such as remote full screen or split mode does not display
local), the local thumbnail image cannot be viewed when adjusting the local camera, so the camera cannot
be accurately adjusted. If you enable preview local, when there is no local screen in the current layout,
the local small window is superimposed in the lower right corner of the screen when you adjust the local
camera. After no PTZ operation within five seconds, the local thumbnail image disappears.
Procedure
1. On your web user interface, go to Setting > Display > Layout.
2. Configure and save the following settings:
Parameter Description Configuration Method
Preview Local
Enable or disable to view
the local thumbnail image by
adjusting camera when there is
no local screen in the current
layout.
On-You can view the local
thumbnail image when you
adjust the camera.
Off-You can not view the
local thumbnail image when
you adjust the camera.
Default: On.
Web user interface

Table of Contents

Other manuals for Yealink VCM38

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink VCM38 and is the answer not in the manual?

Yealink VCM38 Specifications

General IconGeneral
TypeConference microphone
Noise reductionYes
Microphone frequency100 - 16000 Hz
Microphone sensitivity-45 dB
Microphone pick-up range6 m
Number of microphone arrays8
Maximum sound pressure level (1kHz)100 dB
Device interfaceRJ-45
Connectivity technologyWired
Maximum operating distance40 m
Mounting typeCeiling
Product colorSilver
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)5 - 90 %
Number of products included1 pc(s)
Harmonized System (HS) code85181000
Power sourceDC/PoE
Sustainability certificatesCE, Federal Communications Commission (FCC), REACH, RoHS
Weight and Dimensions IconWeight and Dimensions
Width127.3 mm
Height66.3 mm

Related product manuals