5 AC 800F Functional Description
5-11
Rated input power 41 W
Inrush current max. 15. times the peak value of the nominal
current (NAMUR)
Efficiency around 86 %
Thermal power loss with nominal load 6.5 W
Weight 460 g
Connectors Power connector
Diagnostic interface
Module/CPU board
2-pin housing connector GSSA200,
from Hirschmann
9-pin Sub-D connector (male)
96-pin connector
EEPROM
serial, 512 bytes, 10
7
write cycles
Protective separation
from other circuits
not necessary, since device must be
supplied with extra low voltage
For more detailed information about the power supply module and the AC 800F as a
unit please refer to Section 9, Technical data of the AC 800F.
5.2 CPU board PM 802F/PM 803F
The AC 800F basic unit is designed for connecting of a total of six modules and one
power supply module. Two module slots are provided with DMA functionality and,
therefore, are reserved for high-speed communication with the supervisory control
level or for connecting additional process systems through various Ethernet modules.
The remaining four slots F1... F4 don't have direct access to the main memory of the
CPU board, but can trigger various interrupts.
Fig. 5-13 Basic unit with CPU board
To Next Page
Loading...
Need help?
General
