Low Voltage Products & Systems 75
ABB Inc. • 888-385-1221 • www.abb-control.com AC 1006.9 - 5/03
Chapter 7 - Settings and configuration
7:2.4.2 Protections
To set parameters related to the protections, enter the
Protections group.
Overload
Select the required overload type for the application. The
following selections are available:
•No
• Normal
• Dual
Press
Store
to save the selected type.
If overload “Normal” is selected, the following settings
will be available:
Overload class (OL Class)
Select the overload class. Following classes are available:
• 10
• 10A
• 20
• 30
Press
Store
to save the selected class.
Overload type of operation (OL Op)
Select what operation should be initiated if the overload
relay is activated:
Stop– M The motor will stop and a manual reset is required.
Stop– A The motor will stop and an automatic reset is
performed.
Ind Only indication will be given.
Press
Store
to save the selected operation.
Seq. Start
Settings
Functional settings
Start / Stop
Protections
Warnings
Faults
Inputs
Outputs
Fieldbus
Figure 25: Protections group
To Next Page
Loading...
Need help?
General
