Operation
4812160001_A.pdf2014-08-25
Parking
Chocking the drums
Fig. Positioning
1. Chocks
1
Never disembark from the machine when the is
engine running, unless the parking brake is
activated.
Never disembark from the machine when the is
engine running, unless the parking brake is
activated.
Make sure that the roller is parked in a safe place
with respect to other road users. Chock the drums
if the roller is parked on sloping ground.
Make sure that the roller is parked in a safe place
with respect to other road users. Chock the drums
if the roller is parked on sloping ground.
Remember the risk of freezing during the winter.
Fill the engine cooling system and the
screenwash bottle in the cab with suitable
anti-freeze mixtures. See also the maintenance
instructions.
Remember the risk of freezing during the winter.
Fill the engine cooling system and the
screenwash bottle in the cab with suitable
anti-freeze mixtures. See also the maintenance
instructions.
Master switch
1
Fig. Cover, left side
1. Master switch
Before leaving the roller for the day, switch the master
switch (1) to the disconnected position and remove the
handle.
Before switching off the battery isolation switch,
wait for at least 30 seconds after the ignition lock
has been switched off, in order to avoid the
engine's electronic control unit (ECU) sustaining
damage.
Before switching off the battery isolation switch,
wait for at least 30 seconds after the ignition lock
has been switched off, in order to avoid the
engine's electronic control unit (ECU) sustaining
damage.
This will prevent battery discharging and will also
make it difficult for unauthorized persons to start and
operate the machine. Also lock the hood to the engine
compartment.
69
To Next Page
Loading...
Need help?
General
