AudioCodes Mediant 3000 Installation Manual

Version 5.8 47 July 2009
Installation Manual 3. Installation
3.3 Cabling
The cabling of the device must be performed in the following order:
1. Earthing (grounding) the chassis (refer to ''Earthing (Grounding) the Chassis'' on page
47).
2. Connecting the PSTN interfaces:
• 6310 blade:
♦ Connecting STM-1/OC-3 interfaces (refer to ''Connecting STM-1/OC-3 PSTN
Interfaces'' on page 48).
♦ Connecting T3 interfaces (''Connecting T3 PSTN Interfaces'' on page 50).
• 8410 blade: Connecting E1/T1 PSTN interfaces (refer to ''Connecting E1/T1
PSTN Interfaces'' on page 53).
3. Connecting the Gigabit Ethernet (GbE) interfaces:
• 6310 blade: Connecting GbE interfaces (refer to ''Connecting GbE Interfaces to
IP Network'' on page 51).
• 8410 blade:
♦ Connecting Ethernet interfaces to OAMP and Control IP networks (refer to
''Connecting Ethernet Interfaces to OAM and Control IP Networks'' on page
57)
♦ Connecting GbE interfaces (refer to ''Connecting GbE Interfaces to IP
Network'' on page 59).
4. Connecting the BITS sources to the PEM (refer to ''Cabling PEM for BITS Mode'' on
page 60).
5. Connecting the alarm terminal block closures on the PEM module (refer to
''Connecting the Alarm Terminal Block Closures'' on page 61).
6. Con
necting power to the PEM module (refer to ''Connecting Power'' on page 63).
For connecting the device's RS-232 interface to a PC, refer to ''Connecting the RS-232 Port
to a PC'' on page 62.

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English