12. Lamp House & Lamp replacement
12. L AMP HOUSE & LAMP REP LAC EMENT
About this cha pter
This chapter highlights all the supported xeno n lamps for your DP2K -S series projector and ho w to replace the xenon lamp in the
lamp house. Also included is the p rocedure to reset the lamp parameters, which is required after a xenon lamp replacement, and
the procedure to realign the lamp in its reflector for optimal performance.
WARNING: DO NOT PERMIT UN AUTHORIZED PERSONNEL TO PERFORM OR ATTEMPT ANY PHASE OF
XENON LAM P HA NDLING OR SERVICE. ONLY TRAINED AND QUALIFIED TECHNICAL SERVICE PERSONN EL
ARE ALLOWED TO HANDLE THE X ENON LAMP.
CAUTION: Xenon comp act arc lamps are highly pressurized. Wh en ignited, the norm al operating temperature
of the bulb increases the pressure to a level at which the bulb may explode if not handled in strict accord ance
to the manufacturer ’s instructions. The bulb is stable at room temperature, but may still explode if dropped or
otherwise mishandled. W hen ever the lamp house, containing a xenon lam p, has to be dismantled or whenever
the protective container or clo th has to be removed from the xenon lam p, authorized protective clothing MUST
be w orn!
WARNING: Always we ar face p rotection (full face shield) when handling xenon lamps.
WARNING: Alw ays wear p rotective clothing (welder’s jacket) when h andling xenon lamps.
WARNING: Alwa ys wear clean leather g loves with wrist p rote
ctors when handling xen on lamps.
Overview
• Introduction
• Supported xenon lamps
• Lamp replacement process
• Removal of the Lamp Hou se
• Removal of the xenon lamp from the Lamp House
• Installation of the xenon lamp into the Lamp House
• Installation of the Lam p House
• Resetting the lamp parameters
• Realignment of the lamp in its reflec tor
R5977692 DP2K-S SERIES 10/12/2012
77
To Next Page
Loading...
Need help?
General
