EasyManuals Logo
Home>Barco>Projector>DP2K-S Series

Barco DP2K-S Series User Manual

Barco DP2K-S Series
153 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
12. Lamp House & Lamp replacement
12.5 Removal of the xenon lamp from the Lamp House
WARNING: DO NOT PERMIT UN AUTHORIZED PERSONNEL TO PERFORM OR ATTEMPT ANY PHASE OF
XENON LAM P HA NDLING OR SERVICE. ONLY TRAINED AND QUALIFIED TECHNICAL SERVICE PERSONN EL
ARE ALLOWED TO HANDLE THE X ENON LAMP.
WARNING: This procedure may only be performed by qualied technical service p ersonnel.
CAUTION: Xenon comp act arc lamps are highly pressurized. Wh en ignited, the norm al operating temperature
of the bulb increases the pressure to a level at which the bulb may explode if not handled in strict accord ance
to the manufacturer s instructions. The bulb is stable at room temperature, but may still explode if dropped or
otherwise mishandled. W hen ever the lamp house, containing a xenon lam p, has to be dismantled or whenever
the protective container or clo th has to be removed from the xenon lam p, authorized protective clothing MUST
be w orn!
WARNING: Always we ar face p rotection (full face shield) when handling xenon lamps.
WARNING: Alw ays wear p rotective clothing (welders jacket) when h andling xenon lamps.
WARNING: Alwa ys wear clean leather gloves with wrist protectors w hen handling xeno n lamps.
Necessary tools
5mm Allen wre nch.
Lamp protective container or protective c loth with two binders .
Flat blade screw driver.
2.5mm Allen wrench.
17mm open end wrench.
17mm nut driver.
Welder’s jacket (not included in the safety kit that Barco offers).
Full face shield with nec k protection.
Leather gloves with wrist protection.
How to remove the xenon lamp out of the Lamp House?
1. R emov e the hexagon socket head cap screw (reference 1 image 12-15) which fasten the cathode of the x enon lamp. Use a 5
mm Allen wrench. Do not release the c athode wire lug. The screw contains a s pring washer and a plain was her (reference 2 &
3 image 12-15).
Note: The cathode wire remains in its position after the s crew and two washers are removed.
84
R5977692 DP2K-S SERIES 10/12/2012

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Barco DP2K-S Series and is the answer not in the manual?

Barco DP2K-S Series Specifications

General IconGeneral
BrandBarco
ModelDP2K-S Series
CategoryProjector
LanguageEnglish

Related product manuals