Page 161
724-746-5500 | blackbox.com
Chapter 4: Configuration
In Active, the name and detailed information of the current configuration is
shown. This configuration can be saved now.
In Default and File #1 to File #8, the name and the detailed information of the
respective saved configurations are shown. You can overwrite these storage
locations.
The storage location to be overwritten by the current configuration must be
selected explicitly.
Afterwards, the current configuration will be saved to this storage location and
will be immediately shown in the menu. The previously saved configuration that
was saved to this storage location is deleted.
OSD
You can save the created configuration within eight storage locations in the matrix
(File #1–File #8). You can also save a configuration as the default configuration.
1. Select “Configuration > Save As…” in the main menu.
2. Select the required storage location “(File #1–File #8)” or “Default.”
Figure 4-74. Menu Configuration—Save As screen.
To Next Page
Loading...
Need help?
General
