Page 198
724-746-5500 | blackbox.com
Chapter 5: Operation
Alternatively, there are the following keyboard commands available in order to
switch to the local source:
Table 5-6. Switching operations.
Keyboard Command Function
<hotkey>, <k>, <1>,
<Enter>
Switching to extender connection
<hotkey>, <k>, <2>,
<Enter>
Switching to extender connection 2
(only with redundant CON Units)
<hotkey>, <l>,
<Enter>
Switching to the local source
(computer, CPU)
5.5 Multi-Screen Control
Using the Multi-Screen function, you can switch the USB-HID signal between
different statically connected sources (computer, CPU) within a CON Device in two
different ways: via mouse or via keyboard.
Switching via Mouse
You can switch the USB-HID signal by moving the mouse pointer beyond the
edge of the current display to a neighboring display according to the
configuration.
To switch via mouse, proceed as follows:
1. Move the mouse pointer to the edge of the display which that vertically or
horizontally borders the neighboring display.
2. Move the mouse pointer beyond the edge of the display. The mouse pointer
will appear on the respective position at the target display.
The switching option has been performed and the USB-HID signal will now be
available at the target display.
Switching via Keyboard
To switch via keyboard:
1. Start Command Mode with the hotkey.
2. Select the target display by pressing the respective key on the numeric pad of
the keyboard.
The switching option has been performed and the USB-HID signal will now be
available at the target display.
To Next Page
Loading...
Need help?
General
