Canon imagePROGRAF iPF6300S Basic Guide No.3 User Manual

The printer stops during a print job
An error message is shown on the Display Screen ....................................................................................... 1025
The printer ejects blank, unprinted paper ...................................................................................................... 1025
An error message is shown on the Display Screen
Status Corrective Action
An error message is displayed during printing. Check the error message and take action as necessary.
(See "Error Messages.") →P.1049
The last portion of roll paper was used during a print job,
and paper could not be advanced because the trailing
edge is taped to the roll.
Remove the used roll and insert a new roll.
(See "Removing the Roll from the Printer.") →P.790
(See "Removing Rolls From the Roll Holder.") →P.792
(See "Loading and Printing on Rolls.") →P.5
The printer ejects blank, unprinted paper
Status Corrective Action
The leading edge of the roll paper
was cut to straighten it.
The leading edge of rolls may be cut to straighten it if you have selected Trim
Edge First > On or Automatic in the Control Panel menu.
(See "Cutting the Leading Edge of Roll Paper Automatically.") →P.802
The Printhead nozzles are clogged. Print a test pattern to check the nozzles and make sure the Printhead is in good
condition for printing.
(See "Checking for Nozzle Clogging.") →P.980
A print job was received from an
incompatible printer driver.
Use the correct imagePROGRAF printer driver for the printer and try printing
again.
The printer is damaged. Contact your Canon dealer for assistance.
Troubleshooting > The printer stops during a print job >
iPF6300S An error message is shown on the Display Screen
12
1025

Canon imagePROGRAF iPF6300S Basic Guide No.3 Specifications

General

Brand	Canon
Model	imagePROGRAF iPF6300S Basic Guide No.3
Category	Printer
Language	English