End of paper feed.
Cause Corrective Action
You are pressing the â–² button on the Control Panel and trying to rewind the roll to the edge. Release the â–² button.
Borderless printng not possible.
Cause Corrective Action
The print job received specifies a
type or width of paper that is not
compatible with borderless print-
ing.
Follow these steps to change the settings of the print job to enable borderless
printing.
1. Press â–² or â–¼ to select Stop Printing, and then press the OK button.
2. Make sure the correct printer driver for the printer is selected and try printing
again.
For information on types of paper compatible with borderless printing, refer to
the Paper Reference Guide.
(See Paper Reference Guide .)
Select None when you have set Detect Mismatch on the control panel to Warn-
ing.
However, note that this error may cause paper jams and affect the printing quality.
Press â–² or â–¼ to select Print With Border, and then press the OK button to con-
tinue printing. The document will be printed with a border.
The loaded paper is a size not
compatible with borderless print-
ing.
Press â–² or â–¼ to select Stop Printing, and then press the OK button.
Replace the paper with paper compatible for borderless printing as follows.
1. Press â–² or â–¼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.") →P.790
(See "Removing Rolls From the Roll Holder.") →P.792
2. Replace the paper with paper compatible for borderless printing.
(See "Loading Rolls on the Roll Holder.") →P.781
(See "Loading Rolls in the Printer.")
→P.784
The printer now starts printing the print job.
For information on types of paper compatible with borderless printing, refer to
the Paper Reference Guide.
(See Paper Reference Guide .)
Press â–² or â–¼ to select Print With Border, and then press the OK button to con-
tinue printing. The document will be printed with a border.
Because paper expands or con-
tracts depending on the environ-
ment of use, it may become nar-
rower or wider than the supported
width for borderless printing.
Press the OK button to stop printing.
Use each type of paper only where the recommended environmental conditions are
met. For details on environmental conditions for various paper, see the Paper Ref-
erence Guide.
(See Paper Reference Guide .)
Select None when you have set Detect Mismatch in the Control Panel menu to
Warning.
However, note that this error may affect the printing quality.
The paper is loaded askew. Press â–² or â–¼ to select Change Paper and straighten the paper so that the edges
are between the ink grooves for borderless printing.
Insert the roll firmly until it touches the flange of the Roll Holder.
Error Message
>
Messages regarding paper
>
End of paper feed. iPF6300S
13
1060
To Next Page
Loading...
Need help?
General