Cannot calibrate.
Cause Corrective Action
The paper for printing a test pattern is soiled.
Otherwise, you have loaded colored paper.
Press the OK button to clear the error.
Load unused paper compatible with color calibration.
(See Paper Reference Guide .)
The test pattern was printed too faintly. Press the OK button to clear the error.
Take steps to remedy faint printing.
(See "Printing is faint.") →P.1026
Direct sunlight or strong lighting may be shin-
ing on the printer and causing the sensor to
malfunction.
Press the OK button to clear the error.
Take steps to ensure the printer is not used when exposed to direct
sunlight or strong lighting.
Excessive temperature or humidity.
Cause Corrective Action
The temperature or humidity where
the printer is installed is out of the
acceptable range for operation.
Press â–² or â–¼ to select Stop, and then press the OK button to stop printing.
Use the printer under suitable environmental conditions. Also note that various
environmental conditions are recommended for various types of paper. For de-
tails on the recommended environmental conditions, see the Paper Reference
Guide.
(See Paper Reference Guide .)
Press â–² or â–¼ to select Continue, and then press the OK button to continue
with color calibration. However, note that correct adjustment may not be possi-
ble.
Please execute calibration.
Cause Corrective Action
There is not even one color calibration execution result.
This is displayed when paper is loaded in the printer and "Set Exec.
Guide" is set to On on the Control Panel menu.
Execute color calibration.
(See "Using Color Calibration for Color
Adjustment.") →P.844
Set "Set Exec. Guide" to Off on the Con-
trol Panel menu.
(See "Menu Structure.") →P.904
Please calibrate using above paper.
Cause
Corrective Action
It has become the time for prompting the execution of color calibration.
This is displayed when paper is loaded in the printer and "Set Exec. Guide"
is set to On on the Control Panel menu.
Execute color calibration.
(See "Using Color Calibration for Col-
or Adjustment.") →P.844
Set "Set Exec. Guide" to Off on the
Control Panel menu.
(See "Menu Structure.") →P.904
Error Message
>
Messages regarding printing or adjustment
>
Cannot calibrate. iPF6300S
13
1066
To Next Page
Loading...
Need help?
General