Paper Detailed Settings Dialog Box
In the Paper Detailed Settings dialog box, you can set Drying Time for the paper selected with Media Type of the Main
panel, etc.
You can display this dialog box by clicking Set of Media Type on the Main panel. (Refer to "Main Pane
→P.494 ".)
You also can select from the control panel of the printer the items for which you can select Printer Default in this dialog
box. (Refer to "Menu Settings →P.914 ".)
A Media Type
The paper selected with Media Type of the Main panel is displayed.
For information on the types of paper the printer supports, refer to the Paper Reference Guide. (See " Paper Reference
Guide ".)
B Drying Time
Specify the time that the printer waits for ink to dry, as needed. The Drying Time setting is only valid for rolls.
•
C
Between Pages
You can set the time to wait after printing 1 document page until ejecting the paper. Since waiting time is required for
ink to dry before a roll is cut, you can deliver paper in the Output Stacker with the ink dried even if Cutting Mode is
set to Automatic.
Setting Item
Details
Printer Default The setting of the control panel of the printer is applied.
None Paper is ejected immediately after printing completes.
30 sec. / 1 min. / 3 min. / 5 min. /
10 min. / 30 min. / 60 min.
Paper is ejected when the set time elapses after printing completes.
Mac OS X Software
>
Printer Driver
>
Paper Detailed Settings Dialog Box iPF6300S
4
500
To Next Page
Loading...
Need help?
General