Cause Corrective Action
When Detect Mismatch in the Control Panel
menu is set to Warning, paper smaller than the
size specified in the printer driver is loaded.
You can continue to print, but note that this error may cause prob-
lems in the printing results.
The paper is too small.
Cause Corrective Action
A sheet has come out of the printer during
printing.
1. Press the OK button and remove the sheet.
2. Confirm the paper size and setting.
3. Reload the paper.
(See "Loading Sheets in the Feed Slot.")
→P.809
The loaded paper is too small.
(When you have attempted to print a test
print sheet or other printer status informa-
tion.)
Replace the roll with a roll 10 inches in width or larger as follows.
1. Press â–² or â–¼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.") →P.790
(See "Removing Rolls From the Roll Holder.") →P.792
2. Replace the roll with a roll 10 inches wide or larger.
(See "Loading Rolls on the Roll Holder.") →P.781
(See "Loading Rolls in the Printer.")
→P.784
The printer will resume printing.
Press â–² or â–¼ to select Stop Printing, and then press the OK button.
PaprWidth Mismatch
Cause Corrective Action
When Detect Mismatch in the Control Panel menu
is set to Pause or Warning, the width of the loaded
roll does not match the width specified in Fit Roll
Paper Width in the printer driver.
Press â–² or â–¼ to select Print, and then press the OK button to
resume printing.
However, note that this error may cause paper jams and affect
the printing quality.
Press â–² or â–¼ to select Stop Printing, and then press the OK
button.
Follow these steps to replace the roll to match the width speci-
fied in the printer driver.
1. Press â–² or â–¼ to select Change Paper, and then press the
OK button.
(See "Removing the Roll from the Printer.") →P.790
(See "Removing Rolls From the Roll Holder.") →P.792
2. Replace the paper with paper compatible for borderless print-
ing.
(See "Loading Rolls on the Roll Holder.")
→P.781
(See "Loading Rolls in the Printer.") →P.784
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box displayed
when you select Fit Roll Paper Width in the printer driver
matches the width of the roll loaded in the printer, and then try
printing again.
Error Message
>
Messages regarding paper
>
iPF6300S The paper is too small.
13
1053
To Next Page
Loading...
Need help?
General