Canon imagePROGRAF iPF6300S Basic Guide No.3 User Manual

Messages regarding printheads
Cannot adjust printhead. ............................................................................................................................... 1068
PHeads: wrong pos. ..................................................................................................................................... 1068
Wrong x printhead. (x is L, R, or not displayed) ............................................................................................ 1068
x printhead error (x is L, R, or not displayed) ................................................................................................ 1069
No x printhead (x is L, R, or not displayed) ................................................................................................... 1069
Execute printhead cleaning. ......................................................................................................................... 1069
Cannot adjust printhead.
Cause Corrective Action
The Printhead nozzles
are clogged.
Execute Head Posi. Adj. again, as follows.
1. Press the OK button to clear the error.
2. Print a test pattern to check the nozzles.
(See "Checking for Nozzle Clogging.") →P.980
3. Clean the Printhead if the nozzles are clogged.
(See "Cleaning the Printhead.") →P.981
4. Execute Head Posi. Adj. again.
(See "Automatic Adjustment to Straighten Lines and Colors (Head Posi. Adj.).")
→P.827
The Printhead cannot
be aligned; highly
transparent film is
loaded.
Press the OK button to clear the error.
We recommend using a type of paper that you often use, other than film, for Printhead adjust-
ment.
(See "Automatic Adjustment to Straighten Lines and Colors (Head Posi. Adj.).")
→P.827
PHeads: wrong pos.
Cause Corrective Action
The printheads are installed in the
wrong positions.
Open the Top Cover and switch the Printhead used once in the right side to the
right side. Switch the Printhead used once in the left side to the left side.
Wrong x printhead. (x is L, R, or not displayed)
Cause Corrective Action
An incompatible
Printhead has been in-
stalled.
Open the Top Cover. Replace the Printhead L with a new one if Printhead L is displayed and
the Printhead R if Printhead R is displayed. If neither left or right is indicated, replace both
Printhead L and Printhead R with new ones.
(See "Replacing the Printhead.") →P.982
Error Message > Messages regarding printheads >
Cannot adjust printhead. iPF6300S
13
1068

Canon imagePROGRAF iPF6300S Basic Guide No.3 Specifications

General

Brand	Canon
Model	imagePROGRAF iPF6300S Basic Guide No.3
Category	Printer
Language	English