Before borderless printing, move the blue platen switch.
Cause Corrective Action
The blue Switch on the platen was set to the side
opposite ● when a borderless print job was re-
ceived.
Before borderless printing, set the blue Switch on the platen to
the ● side.
(See "Setting the Blue Switch on the Platen.") →P.1033
Blue platen switch is dirty.
Cause Corrective Action
The blue Switch on the platen is dirty. Open the Top Cover and clean the blue Switch on the platen.
(See "Cleaning Inside the Top Cover.") →P.998
Move the blue platen switch No.xx to the right. (xx represents a number)
Cause Corrective Action
The printer has detected that the blue Switch on the
platen needed in maintenance during printing is set
away from the ● mark.
Set blue platen Switch of the indicated number toward the ●
side.
(See "Setting the Blue Switch on the Platen.") →P.1033
Cannot adjust paper feed.
Cause Corrective Action
The Printhead nozzles are clogged. Execute Adj. Quality again, as follows.
1. Press the OK button to clear the error.
2. Print a test pattern to check the nozzles.
(See "Checking for Nozzle Clogging.") →P.980
3. Clean the Printhead if the nozzles are clogged.
(See "Cleaning the Printhead.") →P.981
4. Execute Adj. Quality again.
(See "Automatic Banding Adjustment (Adj. Quality).")
→P.834
Highly transparent film is loaded
that cannot be used for automatic
feed amount adjustment.
Press the OK button to clear the error, and then adjust the feed amount manually.
(See "Manual Banding Adjustment (Adj. Quality).") →P.836
Check printed document.
Cause
Corrective Action
The Printhead nozzles are becoming clogged. If printing is faint, clean the Printhead.
(See "Cleaning the Printhead.") →P.981
Error Message
>
Messages regarding printing or adjustment
>
iPF6300S Before borderless printing, move the blue platen switch.
13
1067
To Next Page
Loading...
Need help?
General