2. On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to select the Settings/Adj. tab ( ).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
3. Press the OK button.
The Set./Adj. Menu is displayed.
4. Press â–² or â–¼ to select Adjust Printer, and then press the OK button.
5. Press â–² or â–¼ to select Feed Priority, and then press the OK button.
6. Press â–² or â–¼ to select Adj. Quality, and then press the OK button.
7. Press â–² or â–¼ to select Manual, and then press the OK button.
Test pattern A is printed for manual adjustment.
Note
• When printing on sheets, follow the instructions on the Display Screen and remove the sheet.
8. Examine test pattern A for adjustment. Determine the pattern in which banding is least noticeable.
Note
• If banding seems least noticeable in two patterns but you cannot decide which one is better, choose an
intermediate value.
For example, choose 11 if you cannot decide whether pattern 10 or 12 is better.
9. Press â–² or â–¼ to select the pattern number you have decided, and then press the OK button.
Test pattern B is printed for adjustment.
Note
• If you printed test pattern A on a sheet, follow the instructions on the Display Screen and use another
sheet of the same type of paper.
Additionally, after test pattern B is printed, follow the instructions on the Display Screen and remove
the sheet.
Adjustments for Better Print Quality
>
Adjusting the feed amount
>
iPF6300S Manual Banding Adjustment (Adj. Quality)
7
837
To Next Page
Loading...
Need help?
General