Item Details
Default
Setting
NCP Burst Mode This mode supports fast data transfer when printing in queue
server mode. Normally, leave the setting On.
On
Print Application Choose the print service.
The print service selected here is enabled. Multiple print services
cannot be enabled simultaneously.
• Bindery PServer
• RPrinter
• NDS PServer
• NPrinter
NDS
PServer
Packet Signature Select If Requested by Server to use packet signature. If Re-
quested
by Server
Bindery PSer-
ver
File Server
Name
Specify the name of a file server that has a NetWare print server.
(0–47 characters)
—
Print Server
Name
Specify the name of a NetWare print server.
(0–47 characters)
—
Print Server
Password
Set a password for the print server.
(0–20 characters)
—
Polling Interval Specify the interval to confirm jobs.
(1–15 seconds)
5
RPrinter Print Server
Name
Specify the name of a NetWare print server.
(0–47 characters)
—
Printer Number Specify the number of the printer connected to the NetWare print
server.
(0-15)
0
NDS PServer Tree Name Specify the name of an NDS tree that has a NetWare print server.
(0–32 characters)
—
Context Name Specify the name of a context that has a NetWare print server.
(0–255 characters)
—
Print Server
Name
Specify the name of a NetWare print server.
(0–64 characters)
—
Print Server
Password
Set a password for the print server.
(0–20 characters)
—
Polling Interval Specify the interval to confirm jobs.
(1–255 seconds)
5
NPrinter Print Server
Name
Specify the name of a NetWare print server.
(0–47 characters)
—
Printer Number Specify the number of the printer connected to the NetWare print
server.
(0-254)
0
7. Complete the following settings based on the selected service.
• If you have selected Bindery PServer: Queue Server Mode (Using a Bindery Print Server)
1. In File Server Name, enter the file server name.
Network Setting
>
NetWare Settings
>
Configuring the Printer's NetWare Network Settings With RemoteUI iPF6300S
10
958
To Next Page
Loading...
Need help?
General