101
You can trim the beginnings and ends of recorded movies in one-second
increments.
Choose *.
● Follow Steps 1 – 3 on p. 33, choose *
and press the m button.
X The movie editing panel and the movie
editing bar will appear.
Set the editing range.
● Press the op buttons and choose or
.
● Press the qr buttons to move . will
display at each one-second interval. If you
choose , you can trim the beginning of
the movie from . If you choose , you
can trim the end of the movie from .
X Even if you move to a point other than a
point, only the portion from the
nearest to the left will be trimmed
when is chosen. Only the portion from
the nearest to the right will be trimmed
when is chosen.
X The light blue section indicated with will
be the section of the movie that remains
after editing.
Check the edited movie.
● Press the op buttons to choose
(Play), then press the m button. The
edited movie will play.
● To edit the movie again, repeat Step 2.
● To cancel editing, press the op buttons,
and choose . After pressing the m
button, press the qr buttons to choose
[OK], and press the m button again.
Movie Editing Bar
Movie Editing Panel
EC277_CUG-E_CDP-E078.book Page 101 Thursday, May 21, 2009 8:16 PM
To Next Page
Loading...
Need help?
General
