User's Manual
207
Figure 5-169 Local alarm
Step 3 Click Setting next to Schedule to configure the alarm schedule.
Step 4 Configure the anti-dither period.
If multiple alarms occur during the anti-dither period, the system only record the
event once.
Step 5 Configure alarm linkage. For details, see Table 5-43.
Step 6 Enable Disarming so that you can connect a switch to the alarm input port for
disarming control.
Step 7 Click Apply.
5.10.4 Alarm Output
Background Information
You can set proper alarm output mode to auto, manual or off. After you connect the alarm
device to the alarm output port of NVR, and set the mode to auto, the system performs
alarm linkage actions when an alarm occurs.
To Next Page
Loading...
Need help?
General
