Product Reference Guide 5
Chapter 2
Setup
Unpacking
Check carefully to ensure the reader and any accessories ordered are present and undamaged. If any damage
occurred during shipment, contact Datalogic Technical Support. Information is shown on page 2.
KEEP THE PACKAGING. Should the unit ever require service
, it should be returned in its original shipping
container.
Setting Up the Reader
ollow the steps provided in this section to connect and get your reader up and communicating with its host.
1. Begin by Installing the Interface Cable
2. Go to Interface Selection and set the desired interface.
3. Configure Interface Settings (only if not using factory settings for that interface).
4. Go to Configuring Other Features (if modifications are needed from factory settings).
To Next Page
Loading...
Need help?
General
