Enter/Exit Programming Mode
186 QuickScan™ I QD24XX
Maxicode Length Control
This feature specifies either variable length decoding or fixed length decoding for this symbology.
Variable Length:
For variable length decoding, a minimum and maximum length may be set.
Fixed Length:
For fixed length decoding, two different lengths may be set.
Maxicode Length Control = Variable Length
Maxicode Length Control = Fixed Length
Maxicode
Set Length 1
Specifies one of the bar code lengths for Maxicode Length Control. Length 1 is the minimum label length if in
Variable Length Mode, or the first fixed length if in Fixed Length Mo
de. Characters can be set from 0001 to 0145
characters in increments of 0001 (pad with zeroes).
See page 217 for detailed instructions on setting this feature.
Select Maxicode Length 1 Setting
To configure this feature, scan
the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
bar c
ode again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
0001 = Length 1 is 1 Character
To Next Page
Loading...
Need help?
General
