Enter/Exit Programming Mode
198 QuickScan™ I QD24XX
Micro QR Code
Set Length 1
Specifies one of the bar code lengths for Micro QR Code Length Control. Length 1 is the minimum label length if
in Variable Length Mode, or the first fixed length if in Fixed Length Mode. Characters can be set from 0001 to
0035
characters in increments of 0001 (pad with zeroes).
See page 217 for detailed instructions on setting this feature.
Select Micro QR Code Length 1 Setting
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters in
Appendix D, Keypad representing your desired charac-
ter(s). End by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to
abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
0001 = Length 1 is 1 Character
To Next Page
Loading...
Need help?
General
