Setup
12 QuickScan™ I QD24XX
Customizing Configuration Settings
Configure Interface Settings
If after scanning the interface bar code from the previous table, your installation requires you to select options to
further customize your reader, turn to the appropriate section for your interface type in "Configuration
Parameters" start
ing on page 15.
• "RS-232 Interface" on page 19
• "RS-232/USB-Com Interfaces" on page 24
• "Keyboard Settings" on page 33
Global Interface Features
See "Global Interface Features" on page 17 for settings configurable by all interface types.
Configuring Other Features
If your installation requires different programming than the standard factory default settings, the following sections
of this manual allow configuration of non-interface-specific settings you might require:
Data Format
:
Data Format offers options to control the messages sent to the Host system.
Reading Parameters
:
Reading Parameters include programming for scanning, beeper and LED indicators and other
universal settings.
Symbology-Specific Parameters
1D Symbologies
:
Includes options concerning the bar code label types (symbologies). These settings allow you to
enable/disable symbologies, set label lengths, require check digit, etc.
2D Symbologies
:
Includes options concerning the bar code label types (symbologies). These settings allow you to
enable/disable symbologies, set label lengths, require check digit, etc.
Software Version Transmission
The software version of the device can be transmitted over the RS-232 and Keyboard interfaces by scanning the
following label.
Transmit Software Version
RevA
To Next Page
Loading...
Need help?
General
