Enter/Exit Programming Mode
Product Reference Guide 193
Micro PDF417 Set Length 2
This feature specifies one of the bar code lengths for Micro PDF417 Length Control. Length 2 is the maximum
label length if in Variable Length Mode, or the second fixed length
if in Fixed Length includes the bar code’s data
characters only. Characters can be set from 0001 to 0366 characters (pad with zeroes) in increments of 01. Any
value greater than 0366 will be considered to be 0366.
See page 217 for detailed instructions on setting this feature.
Select Micro PDF417 Length 2 Setting
To configure this feature, scan
the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
bar co
de again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
Length 2 is 0366 Characters
To Next Page
Loading...
Need help?
General
