Product Reference Guide 245
Appendix B
Standard Defaults
The most common configuration settings are listed in the “Default” column of the table below.
Page references are also provided for featu
re descriptions and programming bar codes for each
parameter. A column has also been provided for recording of
your preferred default settings for
these same configurable features.
Table 49. Standard Defaults
Parameter Default Your Setting
Page
Number
GLOBAL INTERFACE FEATURES
Host Commands — Obey/Ignore
Obey 17
USB Suspend Mode
Disable 17
RS-232 ONLY
Baud Rate
9600 20
Data Bits
8 Data Bits 21
Stop Bits
1 Stop Bit 21
Parity
None 22
Handshaking Control
RTS 23
RS-232/USB-Com
Intercharacter Delay
No Delay 25
Beep On ASCII BEL
Disable 25
Beep On Not on File
Enable 26
ACK NAK Options
Disable 27
ACK Character
‘ACK’ 28
NAK Character
‘NAK’ 28
ACK NAK Timeout Value
200 ms 29
ACK NAK Retry Count
3 Retries 29
ACK NAK Error Handling
Ignore Errors Detected 30
Indicate Transmission Failure
Enable 30
Disable Character
‘D’ 31
Enable Character
‘E’ 31
To Next Page
Loading...
Need help?
General
