Dell S3048-ON User Manual

DHCP MAC Source Address Validation
DHCP MAC source address validation (SAV) validates a DHCP packet’s source hardware address against the client hardware address eld
(CHADDR) in the payload.
Dell Networking OS ensures that the packet’s source MAC address is checked against the CHADDR eld in the DHCP header only for
packets from snooped VLANs.
• Enable DHCP MAC SAV.
CONFIGURATION mode
ip dhcp snooping verify mac-address
Enabling IP+MAC Source Address Validation
IP source address validation (SAV) validates the IP source address of an incoming packet and optionally the VLAN ID of the client against
the DHCP snooping binding table. IP+MAC SAV ensures that the IP source address and MAC source address are a legitimate pair, rather
than validating each attribute individually. You cannot congure IP+MAC SAV with IP SAV.
1 Allocate at least one FP block to the ipmacacl CAM region.
CONFIGURATION mode
cam-acl l2acl
2 Save the running-cong to the startup-cong.
EXEC Privilege mode
copy running-config startup-config
3 Reload the system.
EXEC Privilege
reload
4 Do one of the following.
• Enable IP+MAC SAV.
INTERFACE mode
ip dhcp source-address-validation ipmac
• Enable IP+MAC SAV with VLAN option.
INTERFACE mode
ip dhcp source-address-validation ipmac vlan vlan-id
Dell Networking OS creates an ACL entry for each IP+MAC address pair and optionally with its VLAN ID in the binding table and applies it
to the interface.
To display the IP+MAC ACL for an interface for the entire system, use the show ip dhcp snooping source-address-
validation [interface] command in EXEC Privilege mode.
262
Dynamic Host Conguration Protocol (DHCP)

Dell S3048-ON Specifications

General

Brand	Dell
Model	S3048-ON
Category	Switch
Language	English