no disable
Setting the FRRP Timers
To set the FRRP timers, use the following command.
NOTE: Set the Dead-Interval time 3 times the Hello-Interval.
• Enter the desired intervals for Hello-Interval or Dead-Interval times.
CONFIG-FRRP mode.
timer {hello-interval|dead-interval} milliseconds
• Hello-Interval: the range is from 50 to 2000, in increments of 50 (default is 500).
• Dead-Interval: the range is from 50 to 6000, in increments of 50 (default is 1500).
Clearing the FRRP Counters
To clear the FRRP counters, use one of the following commands.
• Clear the counters associated with this Ring ID.
EXEC PRIVELEGED mode.
clear frrp ring-id
Ring ID: the range is from 1 to 255.
• Clear the counters associated with all FRRP groups.
EXEC PRIVELEGED mode.
clear frrp
Viewing the FRRP Conguration
To view the conguration for the FRRP group, use the following command.
• Show the conguration for this FRRP group.
CONFIG-FRRP mode.
show configuration
Viewing the FRRP Information
To view general FRRP information, use one of the following commands.
• Show the information for the identied FRRP group.
EXEC or EXEC PRIVELEGED mode.
show frrp ring-id
Ring ID: the range is from 1 to 255.
• Show the state of all FRRP groups.
EXEC or EXEC PRIVELEGED mode.
278
Force10 Resilient Ring Protocol (FRRP)
To Next Page
Loading...
Need help?
General
