Layer 2
This chapter describes the Layer 2 features supported on the device.
Manage the MAC Address Table
You can perform the following management tasks in the MAC address table.
• Clearing the MAC Address Table
• Setting the Aging Time for Dynamic Entries
• Conguring a Static MAC Address
• Displaying the MAC Address Table
Clearing the MAC Address Table
You may clear the MAC address table of dynamic entries.
To clear a MAC address table, use the following command.
• Clear a MAC address table of dynamic entries.
EXEC Privilege mode
clear mac-address-table {dynamic | sticky} {address | all | interface | vlan}
• address: deletes the specied entry.
• all: deletes all dynamic entries.
• interface: deletes all entries for the specied interface.
• vlan: deletes all entries for the specied VLAN.
Setting the Aging Time for Dynamic Entries
Learned MAC addresses are entered in the table as dynamic entries, which means that they are subject to aging.
For any dynamic entry, if no packet arrives on the switch with the MAC address as the source or destination address within the timer
period, the address is removed from the table. The default aging time is 1800 seconds.
To disable a MAC address and specify an aging time, use the following commands.
• Disable MAC address aging for all dynamic entries.
CONFIGURATION mode
mac-address-table aging-time 0
• Specify an aging time.
CONFIGURATION mode
mac-address-table aging-time seconds
The range is from 10 to 1000000.
25
Layer 2 435
To Next Page
Loading...
Need help?
General
