CONFIG-FRRP mode.
no disable
Conguring and Adding the Member VLANs
Control and member VLANS are congured normally for Layer 2. Their status as Control or Member is determined at the FRRP group
commands.
For more information about conguring VLANS in Layer 2 mode, refer to the Layer 2 chapter.
Be sure to follow these guidelines:
• All VLANS must be in Layer 2 mode.
• Tag control VLAN ports. Member VLAN ports, except the Primary/Secondary interface, can be tagged or untagged.
• The control VLAN must be the same for all nodes on the ring.
To create the Members VLANs for this FRRP group, use the following commands on all of the Transit switches in the ring.
1 Create a VLAN with this ID number.
CONFIGURATION mode.
interface vlan vlan-id
VLAN ID: the range is from 1 to 4094.
2 Tag the specied interface or range of interfaces to this VLAN.
CONFIG-INT-VLAN mode.
tagged interface {range}
Interface:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
3 Assign the Primary and Secondary ports and the Control VLAN for the ports on the ring.
CONFIG-FRRP mode.
interface primary interface secondary interface control-vlan vlan id
Interface:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
VLAN ID: Identication number of the Control VLAN.
4 Congure a Transit node.
CONFIG-FRRP mode.
mode transit
5 Identify the Member VLANs for this FRRP group.
CONFIG-FRRP mode.
member-vlan vlan-id {range}
VLAN-ID, Range: VLAN IDs for the ring’s Member VLANs.
6 Enable this FRRP group on this switch.
CONFIG-FRRP mode.
Force10 Resilient Ring Protocol (FRRP)
277
To Next Page
Loading...
Need help?
General
