Dell S3048-ON User Manual

Tracking states for 2 resource Ids:
2 - Up IPv6 route, 2040::/64, priority-cost 20, 00:02:11
3 - Up IPv6 route, 2050::/64, priority-cost 30, 00:02:11
The following example shows verifying the VRRP conguration on an interface.
Dell#show running-config interface gigabitethernet 1/8
interface GigabitEthernet 1/8
no ip address
ipv6 address 2007::30/64
vrrp-ipv6-group 1
track 2 priority-cost 20
track 3 priority-cost 30
virtual-address 2007::1
virtual-address fe80::1
no shutdown
Setting VRRP Initialization Delay
When congured, VRRP is enabled immediately upon system reload or boot. You can delay VRRP initialization to allow the IGP and EGP
protocols to be enabled prior to selecting the VRRP Master. This delay ensures that VRRP initializes with no errors or conicts. You can
congure the delay for up to 15 minutes, after which VRRP enables normally.
NOTE: When you reload a node that contains VRRP conguration and is enabled for VLT, Dell Networking recommends that you
congure the reload timer by using the vrrp delay reload command to ensure that VRRP is functional. Otherwise, when
you reload a VLT node congured for VRRP, the local destination address is not seen on the reloaded node causing suboptimal
routing.
Set the delay timer on individual interfaces. The delay timer is supported on all physical interfaces, VLANs, and LAGs.
When you congure both CLIs, the later timer rules VRRP enabling. For example, if you set vrrp delay reload 600 and vrrp
delay minimum 300
, the following behavior occurs:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up and congured for
VRRP.
• When an interface comes up and becomes operational, the system waits 300 seconds (5 minutes) to bring up VRRP on that interface.
To set the delay time for VRRP initialization, use the following commands.
• Set the delay time for VRRP initialization on an individual interface.
INTERFACE mode
vrrp delay minimum seconds
This time is the gap between an interface coming up and being operational, and VRRP enabling.
The seconds range is from 0 to 900.
The default is 0.
• Set the delay time for VRRP initialization on all the interfaces in the system congured for VRRP.
INTERFACE mode
vrrp delay reload seconds
This time is the gap between system boot up completion and VRRP enabling.
The seconds range is from 0 to 900.
Virtual Router Redundancy Protocol (VRRP)
985

Dell S3048-ON Specifications

General

Brand	Dell
Model	S3048-ON
Category	Switch
Language	English