VLT Port Delayed Restoration
When a VLT node boots up, if the VLT ports have been previously saved in the start-up conguration, they are not immediately enabled.
To ensure MAC and ARP entries from the VLT per node are downloaded to the newly enabled VLT node, the system allows time for the
VLT ports on the new node to be enabled and begin receiving trac.
The delay-restore feature waits for all saved congurations to be applied, then starts a congurable timer. After the timer expires, the
VLT ports are enabled one-by-one in a controlled manner. The delay between bringing up each VLT port-channel is proportional to the
number of physical members in the port-channel. The default is 90 seconds.
To change the duration of the congurable timer, use the delay-restore command.
If you enable IGMP snooping, IGMP queries are also sent out on the VLT ports at this time allowing any receivers to respond to the queries
and update the multicast table on the new node.
This delay in bringing up the VLT ports also applies when the VLTi link recovers from a failure that caused the VLT ports on the secondary
VLT peer node to be disabled.
PIM-Sparse Mode Support on VLT
The designated router functionality of the PIM Sparse-Mode multicast protocol is supported on VLT peer switches for multicast sources
and receivers that are connected to VLT ports.
VLT peer switches can act as a last-hop router for IGMP receivers and as a rst-hop router for multicast sources.
Virtual Link Trunking (VLT)
891
To Next Page
Loading...
Need help?
General
