Domino G20I User Manual

INSTALLATION
6-34 EPT024619 Issue 1 June 2016
Set the Unit of Measurement
The procedures below, describe how to set the measurement unit type that
will be used in the printer.
Using the Wireless USB Keyboard
To set the measurement units using the wireless USB keyboard:
(1) From the main menu, highlight Settings.
(2) Press the Enter button.
(3) Move the cursor to highlight Unit.
(4) Press the Enter button.
(5) Move the cursor to highlight either inches or mm.
(6) Press the Enter button.
(7) Press ESC to return to the main menu.
Using a PC
To set the measurement units using a PC:
(1) Open the Domino G20i software.
(2) Open the Printer Control menu.
(3) Select the Unit drop-down menu.
(4) Select either Millimeters or Inches.
Using an Android Device
To set the measurement units using an Android device:
(1) Open the G20i application on the Android device.
(2) Select printer settings.
(3) Select unit.
(4) Select either Millimeter (mm) or Inches.
(5) Select OK.

Domino G20I Specifications

General

Brand	Domino
Model	G20I
Category	Printer
Language	English