OPERATION
3-54 EPT024619 Issue 1 June 2016
Single Counter
In the event of a power failure, when power is restored the counter will
restart from the point of shutdown.
To insert a counter into the message design:
(1) Place the cursor where the counter is required.
(2) Select the Count icon.
(3) Select Single.
(4) The following counter settings can be defined:
(5) Select Insert to confirm the settings and return to the Message
Designer.
Setting Name Explanation
Select counter
number
Select the maximum number of digits in the counter
from 0 to 5.
Start point Enter the starting value for the counter.
Current point Enter the current value for the counter.
Reset point Enter the reset value for the counter. When the
counter reaches this value it will reset to the start
point value.
Count step Enter the number of steps the counter should count
in.
For example, if the Count step value is set to 5, the
counter will count in the sequence:
5, 10, 15, 20, etc.
Fill Zero Turn leading zeros ON or OFF.
Direction Select Up to count upwards.
Select Down to count downwards.
To Next Page
Loading...
Need help?
General
