INSTALLATION
6-48 EPT024619 Issue 1 June 2016
Using a PC
Sensor Mode
To set the print mode as Sensor using a PC:
(1) Open the Domino G20i software.
(2) Open the Printer Control menu.
(3) Change the Printing Mode to Sensor.
(4) The following settings can now be configured:
Continue Mode
To set the print mode as Continue using a PC:
(1) Open the Domino G20i software.
(2) Open the Printer Control menu.
(3) Change the Printing Mode to Continue.
(4) Change the Fixed Length value to the distance between each printed
message. (10 - 10,000)
(5) If the printed message is not to be repeated, tick the No repeat data
tick box.
Type: Select either:
• External - if an external product sensor is
used to trigger printing.
• Internal - if an internal product sensor is
used to trigger printing.
Delay: Change the Before value to set the distance
between when the trigger signal is received
and when the first message is printed.
(10 - 10,000)
Change the After value to set the distance
between messages. (10 - 10,000)
Repeat
Sensor:
Enter the number of times a printed message
should be repeated. (0 - 99)
Fixed Length: Enter the distance between repeated
messages. (10 - 10,000)
To Next Page
Loading...
Need help?
General
