OPERATION
EPT024619 Issue 1 June 2016 3-23
Single Counter
Up to 6 different counters can be inserted into one message.
In the event of a power failure, when power is restored the counter will
restart from the point of shutdown.
To insert a single counter into the message design:
(1) Whilst creating a new message, place the cursor where the counter
should appear.
(2) Press the Insert button on the keyboard.
(3) Move the cursor to highlight Counter.
(4) Press the Enter button.
(5) Move the cursor to highlight Single.
(6) Press the Enter button.
(7) The following counter settings can now be defined:
Notes: (1) Use the arrow keys to move the cursor to the desired setting,
and enter a new value.
(2) Press the Enter button after each setting has been changed to
apply the new value.
(8) Highlight Add counter here.
(9) Press the Enter button.
Setting Name Explanation
Start Enter the starting value of the counter.
Current The current value of the counter.
Reset Enter the reset value for the counter. When the
counter reaches this value it will return to the start
value.
The maximum reset value is: 2,000,000,000.
Step Enter the number of steps the counter should count
in.
For example, if the Step value is set to 5, the counter
will count in the sequence:
5, 10, 15, 20, etc.
The maximum step value is: 250.
Up/Down Select the counting direction, either Up or Down.
Fill Zero Add leading zeros to the start of the counter.
To Next Page
Loading...
Need help?
General
