Configuration and Use Manual 1
Using the Display Using the CommunicatorUsing ProLink IIBefore You Begin
Chapter 1
Before You Begin
1.1 Overview
This chapter provides an orientation to the use of this manual, and includes a pre-configuration
worksheet. This manual describes the procedures required to start, configure, use, maintain, and
troubleshoot the following Series 1000 and Series 2000 transmitters:
• Model 1500 with analog outputs option board
• Model 1700 with analog outputs option board
• Model 1700 with intrinsically safe outputs option board
• Model 2500 with configurable input/outputs option board
• Model 2700 with analog outputs option board
• Model 2700 with intrinsically safe outputs option board
• Model 2700 with configurable input/outputs option board
If you do not know what transmitter you have, see Section 1.3 for instructions on identifying the
transmitter type from the model number on the transmitter’s tag.
Note: Information on configuration and use of Model 2700 transmitters with F
OUNDATION fieldbus
â„¢
,
Model 2700 transmitters with Profibus-PA, and Model 1500 transmitters with the Filling and Dosing
application is provided in separate manuals. See the manual for your transmitter.
1.2 Safety
Safety messages are provided throughout this manual to protect personnel and equipment. Read each
safety message carefully before proceeding to the next step.
1.3 Determining your transmitter type and version
To configure, use, and troubleshoot the transmitter, you must know your transmitter type, installation
type, outputs option board, and several different types of version information. This section provides
instructions for this information. Record this information in the pre-configuration worksheet in
Section 1.7.
To Next Page
Loading...
Need help?
General
