Configuration and Use Manual 259
Index NE53 History
Appendix I
NE53 History
I.1 Overview
This appendix documents the change history of the Series 1000/2000 transmitter software.
I.2 Software change history
Table I-1 describes the change history of the transmitter software. Operating instructions are English
versions.
Table I-1 Transmitter software change history
Date
Software
version
Changes to software
Operating
instructions
08/2000 1.x Software expansion 3600204 A
Added writing of the device tag using Modbus
Software adjustment
Improved communication handling with the HART Tri-Loop
Feature addition
Indication of outputs option board type appears on display at
power-up
05/2001 2.x Software expansion 3600204 B
3600647 A
Added alarm A106 to indicate HART burst mode is enabled
Added access to the transmitter in fault status bit via Modbus
Control of HART burst mode now available via Modbus
Added support for the Model 1700 transmitter
Added support for the I.S. transmitter option
Added support to configure the process variable units for mass flow,
volume flow, density and temperature from the display
Added support for assigning process variables to the milliamp and
frequency output from the display
Software adjustment
Clarified the interaction of the digital fault setting and the last
measured value timeout
Feature addition
Drive gain can be assigned to mA output
Pressure compensation added via HART
Channel B can be configured as a discrete output
To Next Page
Loading...
Need help?
General
