Configuration and Use Manual 125
Measurement Performance TroubleshootingCustody TransferCompensation
Chapter 11
Custody Transfer
11.1 Overview
The following transmitters can be ordered with a custody transfer configuration:
• Model 2700 AN
• Model 2700 CIO
• Model 2500 CIO
A transmitter is appovable for custody transfer if it matches the following model code pattern:
2700(R, C, or B)**(A, B, or C)****W*
or
2500********W*
See Section 1.3.1 for information about how to interpret transmitter model codes.
Notes: The ProLink II procedures provided in this section assume that your computer is already
connected to the transmitter and you have established communication. All ProLink II procedures also
assume that you are complying with applicable safety requirements. See Chapter 3 for more
information.
For transmitters with software versions lower than 5.0, the transmitter behavior and options may be
different than what is described in this chapter. See Section 1.3.2 for information on determining your
transmitter’s software version.
11.2 Locale-specific commissioning
See the Configuration and Use Manual Supplement for your transmitter for information and
instructions on locale-specific commissioning.
11.3 Configuring the weights and measures approval agency
The transmitter must be configured for either National Type Evaluation Program (NTEP) compliance,
which is customary for the United States, or Organization of Legal Metrology (OIML) compliance,
which is customary for most other world areas. By default, the transmitter is configured for OIML
compliance.
The weights and measures agency can be configured in ProLink II. Choose
ProLink > Configuration,
click the
System tab, and choose an area from the Approval list in the Weights and Measures box.
To Next Page
Loading...
Need help?
General
