Emerson Micro Motion 1000 Series User Manual

Configuration and Use Manual 247
Menu Flowcharts – Model 2700 CIO Transmitters
Model 1700/2700 IS Display CodesModel 2700 CIOModel 1700/2700 AN
G.5 Display menus
Figure G-11 Display menu – Managing totalizers and inventories
Figure G-12 Display menu – Off-line menu, top level
STOP/START
(2)
Select
Scroll
RESET
(3)
STOP/START YES?
Process variable
display
RESET YES?
Scroll
Mass total display Volume total display
Scroll
Select
E1--SP
(1)
Yes No
Select Scroll
Scroll
E2--SP
(1)
Scroll
EXIT
Select
Yes No
Select Scroll
Scroll
(1) The Event Setpoint screens can be used to define or change the setpoint for Event 1 or Event 2 in the single-setpoint
event model. These screens are displayed only if the event is defined on mass total or volume total. Note that this
functionality does not apply to discrete events (the dual-setpoint event model). For more information, see
Section 8.11.
(2) The transmitter must be configured to allow starting and stopping totalizers from the display.
(3) The transmitter must be configured to allow resetting totalizers from the display.
Scroll and Select simultaneously
for 4 seconds
VER
OFF-LINE MAINT
Select
SEE ALARM
Scroll
Scroll
Scroll
EXIT
CONFG
Scroll
SIM
Scroll
ZERO
Scroll
SENSOR VERFY
(1)
Scroll
EXIT
(1) This option is displayed only if the transmitter is connected to an enhanced core processor and the meter
verification software is installed on the transmitter.

Emerson Micro Motion 1000 Series Specifications

General

Brand	Emerson
Model	Micro Motion 1000 Series
Category	Transmitter
Language	English