The numeric keypad is displayed.
You can also use the or buttons to decrease or increase the selected value.
Enter the new value of the parameter and press to confirm.
The drilling point has been modified.
Grouping the drilling points
If you need to modify several drilling points simultaneously, you can group them together provided
they are on the same side of the shape (nasal side / temporal side).
By default, the symbol is displayed: each drilling point can be modified individually.
• Press .
> is displayed. All future modifications will be applied to all drilling points in the same way:
◦ only the reference drilling point is modifiable,
◦ the coordinates of the other drilling points are greyed out.
• To un-group the drilling points, press again.
c. Adjusting the position of a drilling point
You have three options for adjusting the position of a drilling point on a shape:
• Use the virtual mouse
• Use the or buttons to reduce or increase the selected value.
• Enter the exact coordinates of the drilling point directly.
The drilling coordinates are those of its entrance drill-hole.
• For a drill-hole, it is the center.
• For a slot and a notch, the entrance point is always on the side which is furthest away from the edge
of the lens:
To Next Page
Loading...
Need help?
General