◦ a general modification of the bevel curve (F p.29)
◦ a modification at a point of the bevel curve (F p.30)
◦ a displacement of the bevel curve (F p.31)
• You can consult the description of the customized bevel screen (F p.26).
a. Automatic beveling
Call up the desired shape located on the tracer or on the job management program.
The shape is displayed on the edger work screen.
After the tracing of a rimmed frame:
• The bevel finish is selected by default.
• The automatic mode is selected by default.
If you want to produce a bevel less than 0.75mm high, configure the bevel directly on the
screen.
Press and to adjust the height of the bevel.
Height (mm)
By default 0.75
Minimum 0.30
Maximum 0.75
Select lens material.
Select the type of cycle.
Choose whether or not to polish and/or chamfer your lens.
For more information, consult the section Edging a lens > Perform a polishing (F p.67) and Edging a
lens > Perform a chamfering (F p.67).
Press the “cycle start” button (front face) or .
The door closes, the lens is clamped, then the feeling operation starts.
The edging cycle starts.
To Next Page
Loading...
Need help?
General