4. Enable area delimitation on the touch screen
5. Modify the selected value
Legend of colours delimiting the shape areas:
(pink) Bevel finish
(yellow) / (orange) Groove finish (in the case of a Groove - Groove mixed job, the colours make it
possible to differentiate grooves with different parameters)
(black) Flat-edge finish
b. Configuring the mixed finish
Initiating a mixed finish
Call up the desired shape located on the tracer or on the job management program.
The shape is displayed on the edger work screen.
Select lens material.
Press to select mixed job mode.
Select your type of cycle.
Choose whether or not to polish the lens.
You cannot do a chamfer on a mixed job.
For more information on polishing, refer to the section Edging a lens > Polishing (F p.67).
Press .
The door closes, the lens is clamped and then felt.
The mixed finish screen is displayed:
The default setting is the bevel - groove finish in automatic mode.
Customizing the mixed finish
Select the desired type of mixed finish.
Press to access the area definition screen.
To Next Page
Loading...
Need help?
General